Forums | Stopping Power | Articles |
All | Accurate Arms | Alliant | Guests | Hodgdon | Vihtavuori | Winchester | Taffin Tests | New Loads | Calibers in list format
All Load Data
Sort by: Powder  Velocity Set alternate row color
22 Handloads
30-06 Springfield, 150 gr
BulletPowder WeightPowderVelocityOALPrimerSource
BTHP 51.5 gr4064 3,000 fps3.2" CCI LR guest
This load gives me excellent accuracy in my model 700 velocity in my mark x mauser with 26" bbl is right at 3000 no pressure signs great accuracy 1.0 in at 100yds some 5 shot strings are less I cant seat the bullet out far enough to touch the rifling The bullet is too short so I just seat it as if it was A factory round

JSP 55.7 grH380 Unknown Win LR guest
Groups average .75 inches at 100 yards from sand bag rest. Best group was .6 with outdoor temperature at 82F and humidity at 65%. Slight breeze of < 5 mph.

BTHP 59.0 grH380 2,956 fps CCI LRM guest

JSP 61.5 grH4831 2,800 fps CCI LR guest
1/2" group @ 100 yds. Weatherby Vanguard Rifle, Nosler Ballistic Tips

BTHP 60.0 grH4831 Unknown Fed LRM guest
Bullet is Nosler 150gr. Ballistic Tip. Seat bullet .005-.010 from lands. Produces less than 1/4 groups at 100yds and 3/4 groups at 200yds.

FMJ 46.0 grH4895 2,600 fps3.18" LR guest
I built this load for the M1 Garand. Hodgdon or IMR 4895 have pretty much the same burn rate and were developed for the M1. This load is very accurate and works the action of the rifle just fine. My main concern here was not over power the op rod and get good performance. I used LR #34 Nato primers.

SP 48.0 grhodgdons 4895 Unknown3.2"" CCI LR guest
remington cases, 150g psp corelokt, remington 710 5 rounds in same hole @ 50 yards. Friend has same rifle and takes 50.0 grains of same powder to mimic results. Guns were made @ factory one after the other. "go figure"

SP 53.0 grIMR 4064 Unknown LP guest
Rem 9 1/2 Large Primer, Norma brass. Sierra Game King Boat tails, Winchester Model 70 22 inch barrel. Poison on PA deer.

BTHP 57.5 grimr 4350 2,860 fps CCI LR guest
A good all around load. I’ve used it in a Savage 110 and a Remington 742 and it has performed well.

JSP 51.0 grIMR 4895 2,965 fps3.20" CCI LR guest
Rem 700 BDL, R-P cases,2.484",ES=7.99, SD=5.65

JSP 48.0 grimr 4895 2,850 fpsna" Fed LR guest
rifle is a 700 rem. 26in. king barrel. this load is very acc. .4 at 100yds. and 1.2 at 300.this was a forming load.

JSP 51.6 grIMR-4064 2,942 fps3.32" CCI LR guest
Rifle FN Mauser 24" bbl, same load shoots Horn 150 gr SST, Horn BT and Speer Hot core, All groups less than 1".

BTHP 60.0 grimr-4350 2,950 fps3.340" Win LR guest
average .75 groups @ 100 yards using hornady sst bullets out of my rem model 710.

SP 54.0 grimr4350 Unknown LR guest

JSP 61.0 grR-19 2,950 fps3.40" CCI LR guest
Rifle is Win. M-70, bullet is Sierra Pro Hunter, primer is CCI-BR2,Case is rem. this is a very accurate 3 shots under 1 in. load close to max.

SP 63.0 grReloader-19 2,998 fps Fed LR guest
2998 ft/sec. measured 12 feet from the muzzle. This 150 grain is the Barnes X flat-base all coppper bullet. The Alliant website lists this load and it is the maximum charge noted there. My Brno action built in 1938 was rebarrelled by Century Arms in .30-06 SPRG. and sold here in Canada. It is a great rifle/cartridge for big-game hunting here in Alberta.

JSP 51.5 grRL-15 2,867 fps CCI LR guest
22" Rem pump rifle.Temp 90 degrees

SP 59.0 grvihtavuori 550 Unknown CCI SP guest

JSP 53.5 grwc846 2,845 fps CCI LRM guest
max work up, powders vary. Ruger 77 22" WW brass, win power point. Temp 80 degrees

SP 48.0 grWin 748 2,810 fps  Winchester
Suggested starting load: 43.2 gr

Pressure: 46,000 CUP

SP 54.0 grWin 760 2,900 fps  Winchester
Suggested starting load: 48.6 gr

Pressure: 48,000 CUP

FS 55.1 grWin 760 2,810 fps  Winchester
Suggested starting load: 49.6 gr

Pressure: 52,100 PSI

Users assume all risk, responsibility and liability whatsoever for any and all injuries (including death), losses or damages to persons or property (including consequential damages), arising from the use of any data, whether or not occasioned by publisher's negligence or based on strict liability or principles of indemnity or contribution. Handloads.Com neither assumes nor authorizes any person to assume for it any liability in connection with the use of any data.

It took 0.03 seconds to build this page

Questions or comments? | Donate to Handloads.Com | Site Map
Copyright © 2000-2008